Re: Broken LS (HD-H120LAN) .. any debug strategies?
- Could be just a bad firmware install. I just replaced a 160GB with a
320 GB after backing up all my data off the old drive. And then used
the firmware updater to put the LS 1.47 firmware I had back into the
unit. I had to do this twice, because the first time always fails.
But then it works ok and starts initializing the drive and
partitioning it and formatting so it will be ready to go.
If your fine with a 120 GB, try this. But for about $100, you can
still get a 320 GB brand new and do what I have stated.
I found the extensive directions on how to do this on the internet,
but doing it is much simpler than how the instructions were written
out. The guy that wrote the instructions made it sound like you had
to jump through hoops and be a grand master at Linux. This was not
so, and I had a working LS in about an hour.
--- In LinkStation_General@yahoogroups.com, "philhochstetler"
> I bought a broken LinkStation. The 120GB hard drive spins up and
> blinking power light goes steady after about 10 seconds but I cannot
> get it to connect over the network connection (no ethernet lights onsmoked
> either end of the cable). I have taken it apart and nothing is
> obviously is broken on the board (no obvious broken traces or
> parts) so I am wondering what are my options?the
> One thought I had was to add a USB network card but I'll bet there
> are not any drivers for such a device by default. I am going to add
> the serial port hack once I find the right parts to build the rs232
> level shifter. That might give me more info about whether the
> ethernet chip is found or not. Can I update the system by taking
> drive to another system? As far as I know it is still running stocksuggestions
> software (but I did buy it second hand so who knows). Any
> on what options I should pursue?