Loading ...
Sorry, an error occurred while loading the content.

DriveStation power problems

Expand Messages
  • Derek Taubert
    For those DriveStation owners also having problems with the unit powering down (especially near cell phones), the whole soft power circuit can be bypassed by
    Message 1 of 1 , Mar 5 5:17 PM
    • 0 Attachment
      For those DriveStation owners also having problems with the unit powering
      down (especially near cell phones), the whole soft power circuit can be
      bypassed by placing 0 ohm resistors (ie: jumper wires) in R53 and R52.

      A photo of the circuit board can be found here:

      http://68.166.220.123/~dtaubert/linkstation/drivestation_circuit_board.jpg

      R53 and R52 are on the right hand side below the power connector.

      The only trick to getting the DriveStation apart is to shove the insides
      forward after removing the back plate (held on with a single screw).

      Hope this helps,
      Derek
    Your message has been successfully submitted and would be delivered to recipients shortly.