Re: OpenLink. Cannot run any commands (vi etc)
- Thanks very much for that... the dropbear start is not in the
The vi and gunzip commands are in the bin directory, but when I try
and run them I get 'command not found'. Can you think of any reasons
--- In LinkStation_General@yahoogroups.com, "isaak_montoya"
> 1. You need to start SSH by yourself.
> a.set root password:
> bash-2.05a# passwd
> Enter new UNIX password:
> Retype new UNIX password:
> passwd: password updated successfully
> b.generate dss & ras key and then start ssh server:
> bash-2.05a# dropbearkey -t dss -f /etc/dropbear/dropbear_dss_host_key
> bash-2.05a# dropbearkey -t rsa -f /etc/dropbear/dropbear_rsa_host_key
> bash-2.05a# /etc/init.d/dropbear start
> Starting Dropbear SSH server: dropbear.
> 2. I don't know why. I have vi and gunzip commands.
> --- In LinkStation_General@yahoogroups.com, "fergusenak"
> <ferguskane@h...> wrote:
> > I apologise if this is something stupid.
> > I have just installed the latest openlink firmware on my MIPS 250
> > linkstation. I've followed the instructions from the readme.
> > However, I have a few problems:
> > 1. I can't connect by SSH. There is no response.
> > 2. I can only run the most basic commands when I telnet in (cannot
> > run vi or gunzip for example.
> > Can someone please explain where my mistake lies?
> > Thanks
> > Fergus