61733RE: Re: [LR_Cos] Help with the Fellowship Cloak Pattern
- Nov 14, 2013Thank you both for your help. I am making this for my husband, for his birthday, which was in October, I had to order fabric and since we live in Alaska it took quite awhile to get here. Needless to say, I am anxious to get started. Again, thank you!
---In LOTR_Costume@yahoogroups.com, <johncarlson72@...> wrote:Oh course you are right Gwen. Meghan's fabric is only 60", so I thought it would be a symmetrical have circle. My own Fellowship Cloak from Stansborough is cut as a half circle. That slight shortness at the front edge helps to keep you from tripping on it, which I have still done ascending stairs. I am just over 6 foot tall. Perhaps it was the sword.The hood is the tricky bit. I made a Hobbit sized one for my youngest, and did not make the neck opening his head size. The hood pattern gave me fits. All the Best, John
Sent from my iPhone
On Nov 14, 2013, at 8:46 AM, <gwynnyd@...> wrote:
And remember to include the width of your shoulders in that length for the front of the cloak! The selvage edge needs to be wider than 120" if you want a cloak that is the full 60" long. On the back, measure from where you want it to start - knee, calf, ankle, whatever - up to your neck, across the width of your shoulders, then back down. If you do not allow for the width of your shoulders and add that in, the round bottom edge of the cloak will hike up on the sides and need to be hemmed much shorter than you expect - by the width of your shoulders - to get it level on the bottom.
---In LOTR_Costume@yahoogroups.com, <johncarlson72@...> wrote:Hi Meghan,The pattern of the cloak is a half circle shape. The actual selvedge is the sides of the cloth as it comes off the loom. These sides have a sort of finished edge to them. The distance between them is your fabrics width. 60 inches from selvedge to selvedge in your case.Pick one of these edges to use as your straight front edges of your cloak. It will hang from your shoulders forming the left 60" side and the right 60" side from the same edge. That is why you need 120".Lay the cloth out on a clean floor such that you can get all 120" of length in one clear area. Now look at the cloth, and pick which selvedge or long side you want for your front edges. Now you get to use a giant compass to create your round bottom edge. You will need a helper or a small heavy object and a piece of string 60" plus a bit long. Now get a bit of tailor's chalk or sewing marker or anything that will produce a non permanent line to follow and tie it on your string. Now measure along that selvedge 60" from your cut end and make a mark. Place the other end of your 60" string on that mark. Now have someone hold the string on the mark, or use your heavy object to hold it you will make an arc with your chalk, marker, starting on the same side, and ending back on the same side. That mark where you are holding the string becomes your center where you will make your neck opening. Hope that helped. I will try to post a drawing tomorrow. Good Luck , John
Sent from my iPhone
On Nov 13, 2013, at 3:44 PM, <urbanmu@...> wrote:Hi,
I just got the fabric to make the fellowship cloak and I'm ready to start, but a little confused. I want the length to be 51". According to the pattern you add 10" to the radius of your desired length, so for me that would be 61", making the diameter 122". However it says that if you plan to use the whole 60" width your straight edge would be 120". I am somewhat of a novice so any advice would be greatly appreciated!
- << Previous post in topic Next post in topic >>