- Bill How much of a bite (in aluminum I assume) did you take when it took out the gears? I routinly take 0.035 with a 1.25 diameter fly cutter; in low gear. BilMessage 1 of 33 , Apr 12, 2004View SourceBill
How much of a bite (in aluminum I assume) did you take when it took out the gears? I routinly take 0.035 with a 1.25 diameter fly cutter; in low gear.
> From: "Bill Collins" <bill_collins14@...>
> Date: 2004/04/12 Mon PM 03:28:56 EDT
> To: GrizHFMinimill@yahoogroups.com
> Subject: [GrizHFMinimill] Re: griz 3in1
> Hi KMc,when using a flycutter it is very important you don't take a
> very large cut.I found out the hard way.The first time I used a
> flycutter in my Grizzly,I took to much of a cut and shattered the
> gears in the mill head and replaced them.Now when I use a flycutter I
> take about.005 cut with each pass.I am seriously considering making a
> set of gears from brass and replacing the plastic gears.
> Of course I only use my flycutter to mill large areas of aluminum
> clamped onto the mill table.It's a lot quicker than using a standard
> end mill over a fairly large surface.
> As for boring with the mill I haven't had any problems.Like any
> machine,there are limits to the amount of material that can be
> removed with each pass.
> Good luck and God Bless.
> Bill C.(Billy Reb)
> Yahoo! Groups Links
- ... I don t like to use pressure, even low pressure, to clear chips. It always seems to blow the chips into places I don t want them to go. And that makesMessage 33 of 33 , Apr 17, 2004View Source--- In GrizHFMinimill@yahoogroups.com, dswr@w... wrote:
> I used low pressure air to clear chips after that. A vacuum wouldI don't like to use pressure, even low pressure, to clear chips.
> most likely be better.
> Leo (pearland, tx)
It always seems to blow the chips into places I don't want them to
go. And that makes clean-up harder. I don't enjoy cleaning up, so
anything that reduces the effort is a Good Thing in my shop!
Using a reducer to allow a smaller nozzle on the vacuum helps
get into tight places - turn one out of plastic or aluminum on the
mini-lathe. Just keep the air flow high enough to keep the vacuum's
motor from melting down.