Loading ...
Sorry, an error occurred while loading the content.
 

Re: Mini-mill table dovetails height

Expand Messages
  • Dave Mucha
    ... I noticed the gibs are pretty bad on mine as well. the screws are kinda-sorta near the reliefs on them, but the marks from the screws show the near miss.
    Message 1 of 9 , Mar 1, 2008
      --- In GrizHFMinimill@yahoogroups.com, "fromday2" <aldayis@...> wrote:
      >
      > Mine is .390 plus / minus .003. The fit and gibs were very poor on
      > mine when new. Very small contact area and the gib adjusting screws
      > were not centered over the gibs so tightening them just wedged them
      > worse. I eventually replaced the factory gib set up with a home brew
      > method.
      >
      > Al

      I noticed the gibs are pretty bad on mine as well. the screws are
      kinda-sorta near the reliefs on them, but the marks from the screws
      show the near miss.

      Dave
    Your message has been successfully submitted and would be delivered to recipients shortly.