3142Re: minimill ?
- May 1 8:57 AMYep, they were all correct and I was wrong, it is a drill press with
an x y table attached. It would be awful shaky for milling.
--- In GrizHFMinimill@yahoogroups.com, "Ron" <ronpierce1@m...> wrote:
> I just ordered the Grizzly G0517, I noticed it says the end mill
> capacity is 1/4 inch, does this mean the depth ? as you mill ? but
> you can use wider endmills ? like 1/2 inch at 1/4 deep per pass ?
- << Previous post in topic Next post in topic >>