Loading ...
Sorry, an error occurred while loading the content.

26804Grizzly Rotary Table gear lash

Expand Messages
  • coffelt2
    Oct 19, 2013

      Novice  miller here, today finished milling circular cut out of 1/4 inch thick aluminum plate. Had chatter problems while turning the table, either climb or conventional style.

      The table has a degree or so of play or slack in rotation unless the friction is locked down tight. (can't advance then, of course)


      My table is a Grizzly H5685, their least expensive. Got mine second hand, but doesn't look like it was ever been out of the very nice box


      Catalog description tells of a lash adjustment screw. I don't see any obvious screw. The lash I have appears to be in the worm drive itself. The worm shaft does not shift, I've snugged up the calibrated shaft dial (a sleeve on the worm shaft) until it begins to bind a little, but the table still has that little bit of very annoying play.


      Is this just normal operation for the least expensive of anything? Do they all have this problem to some degree?.

    • Show all 11 messages in this topic