Loading ...
Sorry, an error occurred while loading the content.

Re: [GenesisRadio] Re: Ok, RX works really well...

Expand Messages
  • Bob Bownes
    One thing of note is that the balun gets warm on tx, but not the transistors (which are on a nice heatsink.
    Message 1 of 17 , Jun 12, 2013
      One thing of note is that the balun gets warm on tx, but not the transistors (which are on a nice heatsink.

      On Wed, Jun 12, 2013 at 12:33 AM, Bob Bownes <bownes@...> wrote:
      Yup. Input is working. I can hear CW on 40M.

      On Wed, Jun 12, 2013 at 12:31 AM, Bruce kf1z <kf1z@...> wrote:

      In Windows sound device settings...
      Make sure that the line input gain is set to "other than 0" later you can
      adjust this for bestr SNR
      Make sure the line in of card is set as input in GSDR soundcard setup.
      Make sure line out of card is set as output.
      G11 set as radio, and multiband option checked ( I think it's got the multiband board, if not, leave it unchecked.)
      Try this little test
      unplug the cable (from G11) that goes to line-input of card
      touch the tip of the plug with your finger, or to a metal desk or PC case etc.
      You should see a bunch of nastyness in GSDR panadapter.
      If you do NOT then the issue is getting GSDR to "see" your soundcard.
      If you DO, then there may be an issue on G11 board.
      I assume you do see some band noise in the panadapter?
      do you hear this static in the headphones?
      From: bownes
      Sent: Tuesday, June 11, 2013 8:36 PM
      Subject: [GenesisRadio] Re: Ok, RX works really well...

      Still trying to get my audio settings correct, and even after reading Goran's document, I'm still a bit confused and feel like I've taken steps backwards.

      I'm running Windows 7, using the onboard sound card of a Dell optiplex 775 (ADI HD Audio).

      At this point, I'm just trying to get ssb/cw rx/tx working. No digital yet.

      I set up as follows:

      Ddriver as WASAPI,
      'To Line In' jack to rear line in input on computer,
      'FM Line Out' to rear speaker output on computer
      (machine has jacks front and back, I'm using the ones in the back, not the 'rear' field speaker output of a 7,1 system or the like)
      QSK On
      NO 'Enable VAC'
      Buffer size: 2048
      Sample rate:48000

      I'm getting no indication of rf in (signal generator or antenna) on the waterfall or headphones connected to the 'Phones' jack.

      At this point, I'm getting frustrated and have forgotten what worked. I re-installed GSDR today in hopes of getting back to where I can rx, but to no avail.

      Can anyone point me in the right direction?

    Your message has been successfully submitted and would be delivered to recipients shortly.