Loading ...
Sorry, an error occurred while loading the content.

Re: [GenesisRadio] Crimping tools.

Expand Messages
  • Bruce KF1Z
    I do not crimp... I solder them. then bend the top crimp ears just a bit with needlenose pliers so they fit the housing. bruce From: Kev Cav Sent: Thursday,
    Message 1 of 5 , May 21, 2013
    • 0 Attachment
      I do not crimp...
      I solder them.
       
      then bend the top "crimp ears" just a bit with
      needlenose pliers so they fit the housing.
       
      bruce
       
      From: Kev Cav
      Sent: Thursday, May 09, 2013 3:24 PM
      Subject: [GenesisRadio] Crimping tools.
       
       

      Greetings from down under,

      I have recently need to crimp the small terminal male connectors as uded
      in the G59. Can anyone suggest a suitable tool suitable for these terminals.

      Thanks.

      Kevin vK4KP

      --
      Sent with Thunderbird and Linux Mint

    • Milo Austin
      Use good heat and as quick solder time as possible to avoid wicking solder up the wire. I have always been a fan of soldering all kinds of terminals. But
      Message 2 of 5 , May 22, 2013
      • 0 Attachment
        Use good heat and as quick solder time as possible to avoid wicking solder up the wire.  I have always been a fan of soldering all kinds of terminals.  But especially with small strand wires, soldering tends to increase the chance of the wire breaking inside the insulation with use. More especially if it is a connector where the wire may be partially used to pull the connector off.  As has been in all soldering instructions since the beginning of electronics, make sure you have a good mechanical connection before soldering.

        My 2 cents,
        Milo, KF5GCF


        On Tue, May 21, 2013 at 11:15 PM, Bruce KF1Z <kf1z@...> wrote:
         

        I do not crimp...
        I solder them.
         
        then bend the top "crimp ears" just a bit with
        needlenose pliers so they fit the housing.
         
        bruce
         
        From: Kev Cav
        Sent: Thursday, May 09, 2013 3:24 PM
        Subject: [GenesisRadio] Crimping tools.
         
         

        Greetings from down under,

        I have recently need to crimp the small terminal male connectors as uded
        in the G59. Can anyone suggest a suitable tool suitable for these terminals.

        Thanks.

        Kevin vK4KP

        --
        Sent with Thunderbird and Linux Mint


      Your message has been successfully submitted and would be delivered to recipients shortly.