1947Re: Best Winter Batteries
- Dec 2, 2009With the higher voltage actual capacity is about the same as the Sanyo Eneloops when both are figured as Watt hours due to the higher voltage out and the voltage versus discharge curve appears to be very flat. Per a engineer's review on Amazon the NiZn cells have better charge retention than normal NIMH but not nearly as good as the low leakage versions such as the Eneloops. His tests say a loss of about 12% of charge per month. The specified number of charge cycles before end of life is also lower than NIMH cells.
--- In Geared_hub_bikes@yahoogroups.com, "Rich" <astronut1001@...> wrote:
> Per their AA size battery data sheet they are only listed for use down to 32F or 0C. The electrolyte is water based. Also capacity is still limited compared to NIMH AA batteries at 1500 mAh Typical. The higher voltage out is IMO good for many applications as it is a lot closer to Alkaline voltage output. No information on rate of discharge while not being used that I have found.
> Bike Forums just had sample photos posted of a couple of bike taillights being run with NIMH AAA batteries and Eveready Lithium cells and the difference in light output was quite noticeable due to the higher voltage of the Lithium cells.
> BTW in AA size these are available at retail from several sources including Amazon.
> Rich Wood
> --- In Geared_hub_bikes@yahoogroups.com, Mark Stonich <mark@> wrote:
> > At 11/30/2009 07:33 AM +0000, Rich wrote:
> > >I agree that dynamo lighting is the best way to go. No riding below
> > >50F would be a bit limiting for some of us due to geographic location.
> > I don't care what the specs. say, I've never found NiMh AAs in bike
> > lights to be a problem down to 0F. I think the LED gives off enough
> > heat to keep the batteries warm. Capacity may well be reduced
> > somewhat, but the colder it gets, the shorter my rides are.
> > Cameras are a different story though.
> > It might be worth asking these folks about cold weather performance
> > of their new NiZn 1.6v AA rechargables.
> > http://www.powergenix.com
> > Prices are comparable to NiMh but you need a NiZn charger.
> > Mark Stonich;
> > BikeSmith Design & Fabrication
> > 5349 Elliot Ave S. Minneapolis, Minnesota 55417 USA
> > Ph. (612) 824-2372 http://bikesmithdesign.com
> > http://mnhpva.org
- << Previous post in topic