Loading ...
Sorry, an error occurred while loading the content.

Re: Unclear cuts, how to improve?

Expand Messages
  • stronkus2003
    Thanks, I will try lower power on heads-phase next time, heads concentrator will have to wait till next project. ... is ... the ... 32 ... at ... for
    Message 1 of 3 , Apr 6, 2008
    • 0 Attachment
      Thanks, I will try lower power on heads-phase next time, heads
      concentrator will have to wait till next project.


      --- In Distillers@yahoogroups.com, "abbababbaccc" <abbababbaccc@...>
      wrote:
      >
      > Dropping the power to 350W during the heads phase would help a lot,
      > your vaporspeed (not counting heat losses) is now 33"/s while 12"/s
      is
      > ideal. Alternatively you could install heads concentrator and skip
      the
      > heads removal phase.
      >
      > Cheers, Riku
      >
      > --- In Distillers@yahoogroups.com, "stronkus2003" <stronkus2003@>
      > wrote:
      > >
      > > Hi, havenĀ“t posted in years but now was the time. I have a still,
      32
      > mm
      > > diameter, 60 cm copper packing with a LM head. I normally run it
      at
      > > about 900 W. quality in the middle cut is good, 93% and drinkable
      > > directly. I easily spot the tails cut but I find it very hard to
      > find
      > > the cut between heads and main run. I do take heads very slow, 1
      > > drop/s. So I ask the Gurus here for advice to improve the cuts or
      > > easier ways to detect it? Lower power? VM-head? The still is
      > basically
      > > ok so I do not want to build a longer/broader column. Thankful
      for
      > > advice.
      > >
      >
    Your message has been successfully submitted and would be delivered to recipients shortly.