(6)Purchase the Kenwood ht cable from byonics, then you simply interface to a 9pin D plug. The pin outs are given on their website, but given we are technically
(4)Thanks for letting me know. Have a nice weekend. Traian N2LOP Sent from my iPhone
(6)Thanks a lot. Finally got it to work Tem N5KWL On Saturday, July 18, 2015 1:46 PM, "Bruce Given firstname.lastname@example.org [DVRPTR_V1]"
Fetching Sponsored Content...
(3)David. . Does the tait have the 9pin d connector on the rear ? If not you can reach the connections needed on solder pads on the radios circuit boards. Let me
(4)Tem What software are you running, if its klx then it can be set too gateway mode. You configure the software with the same callsign as your hilltop repeater.
(3)Try getting the drivers here http://dvrptr.net/files/ Dave-KB1PVH Sent from my Samsung S4
Dave Webb KB1PVH
(3)Right mouse click and choosing "install" didn't help? 73 de Bernd, OE7BSH -- ================================== email@example.com // http://www.qth.at/oe7bsh
Bernd - OE7BSH
(9)Thanks you very much! I got both msg.... Hope you enjoyed your time away... Best 73 de Dick, W7PP ... Thanks you very much! I got both msg....
Dick - W7PP
(7)On 6/06/2015 8:59 AM, Matthew Pitts firstname.lastname@example.org ... Hopefully this finds its way into the VKLink variant of Asterisk, which we use over here
(19)The key here is the jumper located in the GM300 for "digital" to pass through the receiver. Nothing to do with the pins on the back of the radio. Not sure if
Teton Amateur Radio Repeater Association
View First Topic Go to
Loading 1 - 10 of total 10 topics