Loading ...
Sorry, an error occurred while loading the content.

1939-1942 Service Bulletin:

Expand Messages
  • mrcooby
    Removing engine: Remove hood by sliding sideways. Disconnect ground cable and spark cables, close shutoff petcock (coupes), fuel line at carburetor, choke, oil
    Message 1 of 2 , Nov 20, 2008
    • 0 Attachment
      Removing engine:

      Remove hood by sliding
      sideways.

      Disconnect ground cable
      and spark cables, close
      shutoff petcock
      (coupes), fuel line at
      carburetor, choke, oil
      gauge tube line, clutch
      cable on transmission
      bracket, speedometer
      cable at transmission,
      and exhaust tube at
      manifold.

      Remove generator,
      accelerator bracket,
      and starter.

      Block up front end.
      Remove front axle and
      wheels. Drain oil;
      remove oil pan and oil
      suction tube.

      Remove engine mounting
      bolts.

      Support engine and
      remove cap screws
      between transmission
      and flywheel housing.

      Pull engine forward.

      Remove cap screws
      between transmission
      and torque-tube
      adaptor; remove
      transmission.

      Lower engine to floor.

      Raise front of car;
      remove engine from
      below.

      Remove clutch from
      flywheel.

      Replace engine by
      reversing procedure.

      Be sure flywheel
      mounting pins match on
      re-installation!
    • berard_m@bellsouth.net
      I ll keep this till I get a prewar. For God s sake, don t tell Julie I even mentioned a prewar. I d be toast. Burnt toast with smoking crust. Not even
      Message 2 of 2 , Nov 20, 2008
      • 0 Attachment
        I'll keep this till I get a prewar.
          For God's sake, don't tell Julie I even mentioned a prewar. I'd be toast.  Burnt toast with smoking crust. Not even suitable for a sam-itch............peter
        ----- Original Message -----
        From: mrcooby
        Sent: Thursday, November 20, 2008 12:47 PM
        Subject: =CROSLEY= 1939-1942 Service Bulletin:

        Removing engine:

        Remove hood by sliding
        sideways.

        Disconnect ground cable
        and spark cables, close
        shutoff petcock
        (coupes), fuel line at
        carburetor, choke, oil
        gauge tube line, clutch
        cable on transmission
        bracket, speedometer
        cable at transmission,
        and exhaust tube at
        manifold.

        Remove generator,
        accelerator bracket,
        and starter.

        Block up front end.
        Remove front axle and
        wheels. Drain oil;
        remove oil pan and oil
        suction tube.

        Remove engine mounting
        bolts.

        Support engine and
        remove cap screws
        between transmission
        and flywheel housing.

        Pull engine forward.

        Remove cap screws
        between transmission
        and torque-tube
        adaptor; remove
        transmission.

        Lower engine to floor.

        Raise front of car;
        remove engine from
        below.

        Remove clutch from
        flywheel.

        Replace engine by
        reversing procedure.

        Be sure flywheel
        mounting pins match on
        re-installation!

      Your message has been successfully submitted and would be delivered to recipients shortly.