Loading ...
Sorry, an error occurred while loading the content.

761Re: [Cadillac_Performance_Association] introduction

Expand Messages
  • greg and marilyn gemmill
    Oct 6, 2003
    • 0 Attachment
      I will be installing the headers when the motor goes into the Plymouth. I was going to stick them on this summer when I updated the exhaust system, but started to run into some stubborn nuts and studs, and rather than pull the heads off to repair broken parts, I figured I'd just wait until the engine came out. From measuring, and eyeballing from underneath, They look like a clean fit if you can get the original manifolds out of there without busting hardware. I'm not sure what all I may be taking off of the hearse yet. The Front and rear  chrome are beautiful as well as the interior, so I may make some of it available when the time comes. 
                                                                                                                                                                    Greg     
      ----- Original Message -----
      Sent: Monday, October 06, 2003 10:24 AM
      Subject: RE: [Cadillac_Performance_Association] introduction

      Are you parting out the hearse?  How was your clearance with the Sanderson Headers?
       
      -----Original Message-----
      From: Greg [mailto:gandmgem@...]
      Sent: Friday, October 03, 2003 9:04 PM
      To: Cadillac_Performance_Association@yahoogroups.com
      Subject: [Cadillac_Performance_Association] introduction

      Hi All: I just purchased a 1939 Plymouth 4 door (suicide rears) with
      a 3" top chop. It's sitting on a 70 buick chassis & rear end with a
      camaro front clip. I plan on dropping the 472 from my 71 M&M hearse
      into it. The hearse has been fun, but is a little too much car for my
      wife to drive (22' blind spot & a terror to park.) Anyone done a swap
      similar to this, and where might I look for some mild hop-up parts.
      I've already got a set of sanderson block hugger headers, but might
      want to go with an aluminum intake and Holley carb as well as a
      little more cam. Any help would be appreciated.     Greg



      To unsubscribe from this group, send an email to:
      Cadillac_Performance_Association-unsubscribe@yahoogroups.com



      Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.


      To unsubscribe from this group, send an email to:
      Cadillac_Performance_Association-unsubscribe@yahoogroups.com



      Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
    • Show all 6 messages in this topic