Loading ...
Sorry, an error occurred while loading the content.

Re: Mach3 interface & mill

Expand Messages
  • bxtf000001
    Thanks, I ll keep an eye on the temps.
    Message 1 of 5 , Jun 16, 2012
      Thanks, I'll keep an eye on the temps.

      --- In CAMM-3@yahoogroups.com, "robinghewitt" <robinh@...> wrote:
      > I am not au fait with MACH but it may be assuming the Roland stepper drivers will limit the current automatically if you stop stepping, not so.
      > To get standby stepper current you have to release your pull down on pins 1, 39 and 40 on the CTC (may not be possible).
      > Probably won't do any harm if you ignore it but wouldn't hurt to make sure the motors aren't overheating.
    Your message has been successfully submitted and would be delivered to recipients shortly.