Loading ...
Sorry, an error occurred while loading the content.

Re: Mach3 interface & mill

Expand Messages
  • bxtf000001
    Thanks, I ll keep an eye on the temps.
    Message 1 of 5 , Jun 16, 2012
    • 0 Attachment
      Thanks, I'll keep an eye on the temps.


      --- In CAMM-3@yahoogroups.com, "robinghewitt" <robinh@...> wrote:
      >
      > I am not au fait with MACH but it may be assuming the Roland stepper drivers will limit the current automatically if you stop stepping, not so.
      >
      > To get standby stepper current you have to release your pull down on pins 1, 39 and 40 on the CTC (may not be possible).
      >
      > Probably won't do any harm if you ignore it but wouldn't hurt to make sure the motors aren't overheating.
      >
    Your message has been successfully submitted and would be delivered to recipients shortly.