Loading ...
Sorry, an error occurred while loading the content.

Re: [CAMM-3] Contact sensor

Expand Messages
  • jws
    It s a little puck about an inch tall and about 1-1/2 or so in dia, It s used to set the tool length in the Z axis. It has a cord on it with a phone type
    Message 1 of 3 , Apr 17, 2007
    • 0 Attachment
      It's a little "puck" about an inch tall and about 1-1/2" or so in dia, It's used to set the tool length in the "Z" axis. It has a cord on it with a phone type plug on the end that plugs into a socket over by where the front panel plugs in. the sensor isn't necessary if you touch in the same way that you would on any other machine.
      ----- Original Message -----
      Sent: Tuesday, April 17, 2007 10:32 AM
      Subject: [CAMM-3] Contact sensor

      I have a PNC-3000 with most of the accessories and manuals. But never
      had the sensor described in the manual.

      What is this device?
      Is it just an electrical contact?

      Thanks in advance!
      Steve


      No virus found in this incoming message.
      Checked by AVG Free Edition.
      Version: 7.5.446 / Virus Database: 269.5.1/764 - Release Date: 4/17/2007 4:43 AM
    Your message has been successfully submitted and would be delivered to recipients shortly.