Loading ...
Sorry, an error occurred while loading the content.

788Re: [CAMM-3] CopperCAM problems

Expand Messages
  • robinghewitt
    Jun 17, 2014
      > The output on the PCB is only half size of what it should be.
       
      The thing on the CAMM-3 that is out by a factor of 2 is the steppers.
       
      Steppers are usually 200 full steps/rev, 1.8 degrees.
       
      The CAMM-3 has 400 full steps/rev, 0.9 degrees.
       
    • Show all 3 messages in this topic