Loading ...
Sorry, an error occurred while loading the content.

4027Re: [BUG] Re: Wiring questions

Expand Messages
  • Charles Martin
    Dec 1, 2010
    • 0 Attachment
      Thanks for checking, Steve. I just looked at mine, and the lights are inside the same box that holds the dose switch, so I guess it is wired through the ribbon cable. I think I'll go ahead and cut off the level sensor where it flattens out, and use the old connector. I'm getting impatient. Too bad I have to work. <g>

      Chuck

      On Dec 1, 2010, at 3:50 PM, Tim Fischer wrote:

      > Chuck,
      >
      > The wiring diagram I got with my knob version of the ES-1A simply shows a Ribbon
      > Cable going from the electronic controller to the Control & Indicator Panel. So
      > not much help...
      >
      > ________________________________
      > From: ssappeals <clmartin@...>
      > To: BUG-is-Bunn@yahoogroups.com
      > Sent: Tue, November 30, 2010 7:02:42 PM
      > Subject: [BUG] Re: Wiring questions
      >
      > I just remembered another question I had about wiring. Both of the front lights
      > are missing, and I don't have a wiring diagram or anything to help me figure out
      > what to get or where to connect it. Any ideas? If it matters, this machine is
      > one with the steam and water knobs on top.
      >
      > Chuck
      >
      > --- In BUG-is-Bunn@yahoogroups.com, "ssappeals" <clmartin@...> wrote:
      > >
      > > I'm nearing completion of the reassembly of my machine, and have a few
      > >questions for those of you with experience:
      > >
      > > 1) The level sensor rod is flattened on the end, so it won't fit into the old
      > >connector. Is there any reason not to just cut the flat part off? And does it
      > >need the 90 degree angle I see that they all have, but mine doesn't?
      > >
      > > 2) Where is a good place to get the power for the PID? I could cut off the
      > >connector on the power cable and put the power leads for the PID along with the
      > >power leads into a new connector. Any reason not to? Or easier idea?
      > >
      > > 3) Are there any tests that can be done once everything is assembled short of
      > >putting the intake hose in water and turning it on?
      > >
      > > Along the way, I had numerous other questions, but taking it slowly, most of
      > >them answered themselves. Today I used a test meter to verify all the wires from
      > >the control box were connected to the right things, so I think I'm good once I
      > >connect the PID and replace the connectors where the heater element connects to
      > >the switch. I plan to replace those wires and include the SSR in the loop. I'm
      > >getting close enough to smell the coffee!
      > >
      > > Chuck
      > >
      >
      > [Non-text portions of this message have been removed]
      >
      >
    • Show all 8 messages in this topic