Loading ...
Sorry, an error occurred while loading the content.

4026Re: [BUG] Re: Wiring questions

Expand Messages
  • Tim Fischer
    Dec 1, 2010
    • 0 Attachment
      Chuck,

      The wiring diagram I got with my knob version of the ES-1A simply shows a Ribbon
      Cable going from the electronic controller to the Control & Indicator Panel. So
      not much help...





      ________________________________
      From: ssappeals <clmartin@...>
      To: BUG-is-Bunn@yahoogroups.com
      Sent: Tue, November 30, 2010 7:02:42 PM
      Subject: [BUG] Re: Wiring questions


      I just remembered another question I had about wiring. Both of the front lights
      are missing, and I don't have a wiring diagram or anything to help me figure out
      what to get or where to connect it. Any ideas? If it matters, this machine is
      one with the steam and water knobs on top.


      Chuck

      --- In BUG-is-Bunn@yahoogroups.com, "ssappeals" <clmartin@...> wrote:
      >
      > I'm nearing completion of the reassembly of my machine, and have a few
      >questions for those of you with experience:
      >
      > 1) The level sensor rod is flattened on the end, so it won't fit into the old
      >connector. Is there any reason not to just cut the flat part off? And does it
      >need the 90 degree angle I see that they all have, but mine doesn't?
      >
      > 2) Where is a good place to get the power for the PID? I could cut off the
      >connector on the power cable and put the power leads for the PID along with the
      >power leads into a new connector. Any reason not to? Or easier idea?
      >
      > 3) Are there any tests that can be done once everything is assembled short of
      >putting the intake hose in water and turning it on?
      >
      > Along the way, I had numerous other questions, but taking it slowly, most of
      >them answered themselves. Today I used a test meter to verify all the wires from
      >the control box were connected to the right things, so I think I'm good once I
      >connect the PID and replace the connectors where the heater element connects to
      >the switch. I plan to replace those wires and include the SSR in the loop. I'm
      >getting close enough to smell the coffee!
      >
      > Chuck
      >







      [Non-text portions of this message have been removed]
    • Show all 8 messages in this topic