Loading ...
Sorry, an error occurred while loading the content.

4025Re: [BUG] Re: Wiring questions

Expand Messages
  • Charles Martin
    Dec 1, 2010
    • 0 Attachment
      Thanks, Steve!

      Chuck

      On Dec 1, 2010, at 11:46 AM, Steven wrote:

      >
      > I will take a picture of mine and post it in my folder no problem that should help out.
      >
      > Steve
      > --- In BUG-is-Bunn@yahoogroups.com, Charles Martin <clmartin@...> wrote:
      > >
      > > Thanks, Steven.
      > >
      > > That manual is the same one that is in the group files section. I used it to verify the connections to the control unit. It doesn't show the lights, though. I'm sure I can figure it out, though.
      > >
      > > Chuck
      > >
      > > On Dec 1, 2010, at 10:25 AM, Steven wrote:
      > >
      > > >
      > > > Chuck
      > > > Here is the wiring diagram for my BUNN levers on bottom , I not completely sure but i think the wiring is the same. http://www.bunnomatic.com/pdfs/commercial/manuals/10712.0000.pdf
      > > > As for the PID it's in the links to the left. TEX does a great job of describing what to do and how to do it.
      > > >
      > > > Steve
      > > > --- In BUG-is-Bunn@yahoogroups.com, "ssappeals" <clmartin@> wrote:
      > > > >
      > > > > I just remembered another question I had about wiring. Both of the front lights are missing, and I don't have a wiring diagram or anything to help me figure out what to get or where to connect it. Any ideas? If it matters, this machine is one with the steam and water knobs on top.
      > > > >
      > > > > Chuck
      > > > >
      > > > > --- In BUG-is-Bunn@yahoogroups.com, "ssappeals" <clmartin@> wrote:
      > > > > >
      > > > > > I'm nearing completion of the reassembly of my machine, and have a few questions for those of you with experience:
      > > > > >
      > > > > > 1) The level sensor rod is flattened on the end, so it won't fit into the old connector. Is there any reason not to just cut the flat part off? And does it need the 90 degree angle I see that they all have, but mine doesn't?
      > > > > >
      > > > > > 2) Where is a good place to get the power for the PID? I could cut off the connector on the power cable and put the power leads for the PID along with the power leads into a new connector. Any reason not to? Or easier idea?
      > > > > >
      > > > > > 3) Are there any tests that can be done once everything is assembled short of putting the intake hose in water and turning it on?
      > > > > >
      > > > > > Along the way, I had numerous other questions, but taking it slowly, most of them answered themselves. Today I used a test meter to verify all the wires from the control box were connected to the right things, so I think I'm good once I connect the PID and replace the connectors where the heater element connects to the switch. I plan to replace those wires and include the SSR in the loop. I'm getting close enough to smell the coffee!
      > > > > >
      > > > > > Chuck
      > > > > >
      > > > >
      > > >
      > > >
      > >
      >
      >
    • Show all 8 messages in this topic