Loading ...
Sorry, an error occurred while loading the content.

Re: Beacon on port 2

Expand Messages
  • wd6dfh
    Thanks agn John. I just turned it of and combined what I had with BTEXT which goes out on Port 1. 73, Todd wd6dfh
    Message 1 of 5 , Dec 21, 2010
    • 0 Attachment
      Thanks agn John. I just turned it of and combined what I had with BTEXT which goes out on Port 1.

      73,
      Todd wd6dfh

      --- In BPQ32@yahoogroups.com, "John Wiseman" <john.wiseman@...> wrote:
      >
      > No, ID messages are different. They are designed to satisfy the requirements
      > of some administrations to send a periodic identiification in the mode being
      > used, so are sent to all ports if enabled.
      >
      > 73,
      > John
      >
      >
      > -----Original Message-----
      > From: BPQ32@yahoogroups.com [mailto:BPQ32@yahoogroups.com] On Behalf Of
      > wd6dfh
      > Sent: 21 December 2010 20:28
      > To: BPQ32@yahoogroups.com
      > Subject: [BPQ32] Re: Beacon on port 2
      >
      >
      >
      >
      > Thanks John. Still learning. Hope that kills the ID broadcast on Port 2
      > also.
      >
      > 73,
      > Todd wd6dfh
      >
      > --- In BPQ32@yahoogroups.com <mailto:BPQ32%40yahoogroups.com> , "John
      > Wiseman" <john.wiseman@> wrote:
      > >
      > > Todd,
      > >
      > > Remove the UNPROTO= statement from Port 2 config.
      > >
      > > 73,
      > > John
      > >
      > >
      > > -----Original Message-----
      > > From: BPQ32@yahoogroups.com <mailto:BPQ32%40yahoogroups.com>
      > [mailto:BPQ32@yahoogroups.com <mailto:BPQ32%40yahoogroups.com> ] On Behalf
      > Of
      > > wd6dfh
      > > Sent: 21 December 2010 19:28
      > > To: BPQ32@yahoogroups.com <mailto:BPQ32%40yahoogroups.com>
      > > Subject: [BPQ32] Beacon on port 2
      > >
      > >
      > >
      > >
      > > I have BPQ32 setup on two ports and would like to BEACON on Port 1 only
      > > however it BEACONS on both. Both ports are BPQtoAGW. Is this possible and
      > if
      > > so what do I set in Port 2 setup?
      > >
      > > Thanks
      > > Todd wd6dfh
      > >
      >
    Your message has been successfully submitted and would be delivered to recipients shortly.