Loading ...
Sorry, an error occurred while loading the content.
 

Re: Netrom Not being Broadcasted

Expand Messages
  • vk2dot
    John thanks. Your statement of last param on the APPLICATION line. Normally this would be set to 255 done the job. All now working OK. regards Rod....///
    Message 1 of 3 , Oct 13, 2010
      John thanks. Your statement of "last param on the APPLICATION line. Normally this would be set to 255" done the job. All now working OK.

      regards Rod....///


      --- In BPQ32@yahoogroups.com, "John Wiseman" <john.wiseman@...> wrote:
      >
      > Rod,
      >
      > If you are sending your node, but not your application calls, then
      > either you don't have NODE=1 and BBS=1 in the config, or the application
      > qualities are too low - either the APPLnQUAL if using the old config
      > method, or the last param on the APPLICATION line. Normally this would
      > be set to 255, unless you have a good reason for anything else.
      >
      > 73,
      > John
      >
      >
      > -----Original Message-----
      > From: BPQ32@yahoogroups.com [mailto:BPQ32@yahoogroups.com] On Behalf Of
      > vk2dot
      > Sent: 12 October 2010 11:14
      > To: BPQ32@yahoogroups.com
      > Subject: [BPQ32] Netrom Not being Broadcasted
      >
      >
      >
      >
      > Hi All, We seem to be having problems with netrom.
      > My main Node sends out VK2DOT-1 broadcast from the BPQ32 Node, OK;
      > But will not send out the BBS VK2DOT-0 or CHat VK2DOT-11 netrom
      > broadcasts.
      > My remote nodes are the same [similar values] setup to my main node.
      > My remote Nodes or other BBS forwarding stations & chat links are not
      > getting all my nodes. [via the AXUDP links.
      > They only receive VK2DOT-1, my BPQ32 Node.
      >
      > Below is a copy of what we think are relevant entries.
      > Has anybody any ideas.
      >
      > Regards Rod....////
      >
      > NODESINTERVAL=30 ; Nodes broadcast interval in minutes
      > L3TIMETOLIVE=25 ; Max L3 hops
      > L4RETRIES=3 ; Level 4 retry count
      > L4TIMEOUT=60 ; Level 4 timeout in seconds s/b > FRACK x RETRIES
      > L4DELAY=10 ; Level 4 delayed ack timer in seconds
      > L4WINDOW=4 ; Level 4 window size
      > MAXLINKS=63 ; Max level 2 links
      > MAXNODES=128 ; Max nodes in nodes table
      > MAXROUTES=64 ; Max adjacent nodes
      > MAXCIRCUITS=128 ; Max L4 circuits
      > MINQUAL=168 ; Minimum quality to add to nodes table
      >
      > ; AX/IP/UDP port definition.
      > QUALITY=192 ; Quality factor applied to node broadcasts
      > MINQUAL=170 ; Entries in the nodes table with qualities
      > <eop>
      >
    Your message has been successfully submitted and would be delivered to recipients shortly.