Loading ...
Sorry, an error occurred while loading the content.
 

Re: [BPQ32] BPQ in a TNC?

Expand Messages
  • JJ
    ... Would this work in a kam? Regards, John
    Message 1 of 5 , Feb 10, 2009
      John Wiseman wrote:

      It could be rewritten, but it would be a pretty major job.
       
      I did the Data Engine version.
       
       
      John G8BPQ
       
      -----Original Message-----
      From: BPQ32@yahoogroups. com [mailto:BPQ32@ yahoogroups. com] On Behalf Of Enki
      Sent: 10 February 2009 19:15
      To: BPQ32@yahoogroups. com
      Subject: RE: [BPQ32] BPQ in a TNC?


      The Atmel ATmega line are not 80x86 compatible. But the assembler
      code could be rewrited. What would be the minimum RAM memory needed?

      BTW, who did the DataEngine version?

      Thanks.
      Mark Jordan - PY3SS

      On 10 Feb 2009 at 17:56, John Wiseman wrote:

      >
      > I don't know the ATmega128. If it has an Intel 80x86 compatible processor then it is possible,
      > otherwise very unlikely, as most of the low level code is written in 8086 assembler.
      >
      > 73;
      > John G8BPQ
      >
      >
      > -----Original Message-----
      > From: BPQ32@yahoogroups. com [mailto:BPQ32@yahoogroups. com] On Behalf Of Enki
      > Sent: 10 February 2009 17:43
      > To: BPQ32@yahoogroups. com
      > Subject: [BPQ32] BPQ in a TNC?
      >
      >
      > Is there a chance of porting the BPQ code to run on a small TNC?
      > I mean something like a TNC based on an Atmel ATmega128 with
      > external RAM. I only know the Kantronics DataEngine.
      >
      > Mark Jordan - PY3SS
      >
      >
      >
      >
      >

      Would this work in a kam?
      Regards,
      John

    Your message has been successfully submitted and would be delivered to recipients shortly.