RE: [BPQ32] Re: Is BPQ32_410i_2009Feb07 working for everyone?
MessageHi Mike, well spotted!Yes, the suspect KISS code in 4.10h added the ASYNC label, but this was reverted when I went back to the old kiss code. Once I work out what was going wring with the new code you'll get the label back again.73,John-----Original Message-----
From: BPQ32@yahoogroups.com [mailto:BPQ32@yahoogroups.com] On Behalf Of Mike Ligeza
Sent: 09 February 2009 16:17
Subject: [BPQ32] Re: Is BPQ32_410i_2009Feb07 working for everyone?
--- In BPQ32@yahoogroups. com, Ron Stordahl <ron_n5in@.. .> wrote:
> The KISS problem in the release of BPQ32_410h_2009Feb0 4 was a bit
unusual. Some users didn't experience the problem, others did. In
testing when I connected by radio to the AR-Cluster application call
it worked just fine. After the problem was reported I soon found that
if I connected to the node and typed a 'N' the columns didn't line up
as the lines were wrapped, as if they were missing their CR-LF
> Fortunately the installer is designed to allow you to go forward (by
running the current installer) or to go back (by running an older
installer) so quickly running BPQ32_410g_2008Dec2 5.exe would put you
back on the air. I should mention that you cannot go 'way back'. I
can't recall when I changed the installer to allow this...perhaps a
year ago. Prior to then all bets are off!
> Ron, N5IN
Installed with no problems. Running with the G8BPQ modified version
of WinFBB 7.01.35a
But I notice that in the BPQ32Console Window where the line says
"Initialising Port 1 ...." It used to says "ASYNC" I think, but now it
is blank. This is on two Radio Ports that I am running using KISS
mode TNCs (PK232).
The Ports appear to be working OK.