Loading ...
Sorry, an error occurred while loading the content.

820Re: [BPQ32] TNC2-Kissmode

Expand Messages
  • Mike Reed
    Nov 5, 2007
    • 0 Attachment
      I was afraid that is what was going to have to happen. I have a prom burner, did several of the digi nodes around here...wher do I find this file??
       
       73
       Mike - N7ZEF
       
      ----- Original Message -----
      From: Dave Zeph
      Sent: Monday, November 05, 2007 7:06 PM
      Subject: RE: [BPQ32] TNC2-Kissmode

      Mike …. The best way to run a 1270C in KISS is to replace the MFJ Firmware EPROM, U23, with a JKISS EPROM.  This is a KISS-Only EPROM, the code for which is par of the V4.08 release. 

       

      Find someone with an EPROM Programmer to burn one for you and you’ll not have this prolem again.

       

       

       

      73 -à Dave, W9ZRX

       

       


      From: BPQ32@yahoogroups.com [mailto:BPQ32@yahoogroups.com] On Behalf Of n7zef
      Sent: Monday, 05 November, 2007 20:40
      To: BPQ32@yahoogroups.com
      Subject: [BPQ32] TNC2-Kissmode

       

      Howdy;
      With some help of a few other sysops out there, I do have my WinFBB
      going w/BPQ 4.08. And works well.
      One extra problem I am having is that the TNC2 tnc I am using (1270c)
      will fall out of kiss mode, and I have to use Hyperterm to put it back
      into kiss mode.
      Is there a special setting to do this, a program I need to run, or
      what?
      What about using a simple Baycom TNC. I have one, and would like to
      use it sometime soon. What about programs / settings for that?

      Thanks for helping out all...

      73
      Mike - N7ZEF

    • Show all 15 messages in this topic