Loading ...
Sorry, an error occurred while loading the content.

6548Re: lost port settings

Expand Messages
  • don.w9jun
    Aug 12, 2011
    • 0 Attachment
      Ken, ports 93 and 10093 (udp) and ports 8010 and 8011 (tcp) right? The odd thing is that I can connect using bpqtcp from home using my dyndns address but not away from home.

      --- In BPQ32@yahoogroups.com, Ken Jacobs <kd6pgi@...> wrote:
      >
      > Hi Don,
      >
      > I know the Westell Routers are a pain to setup port forwarding if you don't
      > know where to look. I recall that the port forwarding setup is under
      > FIREWALL SETTINGS. You then need to create a new profile such as BPQ. Then
      > you can add specific port forwarding info to that profile....ie ports 93,
      > 10093, 8010, 8011, etc.
      >
      > The PortStart, PortEnd and Base HostPort should all be the same value for
      > each entry....ie 10093, etc. And of course, make sure all the ports point to
      > the IP address of your BPQ computer.
      >
      > Hope that helps....
      >
      > Ken KD6PGI
      >
      >
      > On Thu, Aug 11, 2011 at 2:50 AM, don.w9jun <don.porter@...> wrote:
      >
      > > **
      > >
      > >
      > > My DSL went down (which is back up) and now I am using a Westell modem. The
      > > port settings are confusing. I need to setup my ports again; 93, 10093,
      > > 8010, 8011..Anyone familiar with the westell modem frontier uses?
      > >
      > > Here are the parameters:
      > > Protocol Global PortStart Global PortEnd Base HostPort
      > >
      > >
      > >
      >
    • Show all 12 messages in this topic