3933Re: [BPQ32] Issues with BPQEther port ?
- Sep 28, 2010On 8/28/2010 4:16 PM, John Wiseman wrote:
> It don't think there are any issues, so long as you are careful with theI found today that my firewall (Sygate Personal Firewall) is the
> config. In particular I had a problem with a router/switch when I did'nt
> have the source mac address set correctly.
> What problems are you having?
obstacle that causes the problem of 'freezing' the ethernet link between
BPQ 4.08a (or 4.09d) on a DOS machine, and BPQ32 on a Windows machine.
When the firewall is on (well, always), the ethernet link goes down or
better to say 'freezes' after a while. I mean, when I activate both ends
of the ethernet link, the nodes keep exchanging their node-lists,
beacons etc without problems. When I add some traffic (Eg. forwarding
between two bbs's running on top of BPQ), everything goes fine but only
for some few minutes, but soon after the BPQ32 side seems to lose its
capability to 'hear' the other side of the link and 'freezes' itself
(sometimes it freezes the whole computer). However, sometimes I still
get beacons and node-lists from the DOS machine (i see them coming in
the BPQ32 monitoring window), but BPQ32 seems to be incapable to
'digest' incoming information and include it to its own node-list, etc.
When I switch off the firewall and wait half a minute, the frozen link
'melts' and continues to work. Any suggestion what to do to avoid that
This is my test station:
VHF |MS DOS 5 comp| |MS Windows 2000 comp|
TRX--TNC2--|BPQ4.09d, PZT| --- LAN --- | BPQ32 4.10n, FBB |-- I'net
ant ------------- --------------------
YT7M-1 (BPQ) YT7MPB-3 (BPQ32)
YT7M (PZTBBS) YT7MPB-4 (FBB)
> Do you have a LAN monitor? - I use Wireshark, and if you install my pluginsI just tested the packets by using Ethereal and noticed that all packets
> it will decode bpqether and axip packets.
between two nodes were of protocol type '08FF' (is that a 'BPQ protocol'?)
- << Previous post in topic Next post in topic >>