Loading ...
Sorry, an error occurred while loading the content.

Re: Close Call Modes

Expand Messages
  • CL
    I think I understand better. DND means CC can not start a scan if there is currently a channel active. PRI means CC can interrupt an active channel to start a
    Message 1 of 4 , Jul 18 10:15 PM
    • 0 Attachment
      I think I understand better.

      DND means CC can not start a scan if there is currently a channel active.

      PRI means CC can interrupt an active channel to start a scan. I assume this is why I get those 2s pauses sometimes.


      And so override means if CC does happen to find a signal, it will immediately jump to it. Right?


      --- In BC346XT@yahoogroups.com, Keith <kilowattradio@...> wrote:
      >
      > * CL <fles_dnoyeb@...> wrote:
      >
      > > What do the close call modes do?
      > >
      > > Off - obvious
      > > DND - ?
      >
      > Close Call Do Not Disturb sets the radio so that when the
      > radio is receiving a signal it will not interupt it by
      > cutting way to check the band of frequencies.
      >
      >
      > > PRI - ?
      >
      > Close Call Priorty allows Close Call to cut away and switch to Close signals
      > in the band you turn on.
      >
      >
      > >
      > > I was thinking DND just stored the hits, while PRI presented them to you immediately. However, since there is a menuitem for CC Override I don't think that is accurate.
      > >
      > > Any idea?
      > >
      > --
      > Best Regards, Keith
      > http://home.comcast.net/~kilowattradio/
      >
    Your message has been successfully submitted and would be delivered to recipients shortly.