Fraser, I do not have an IC-7600, but do have an IC-7700. I rarely use this rig for the digital modes, but I did set it up to work with WSJT-X v1.1 as a backupMessage 1 of 3 , Jul 27View SourceFraser,
I do not have an IC-7600, but do have an IC-7700. I rarely use this rig for the digital modes, but I did set it up to work with WSJT-X v1.1 as a backup to my Flex-5000. As I recall, I had problems until I went into the setup menus and set C-IV off...try that if you have not already done so.
Good luck!Ed, K0KC
From: Ed <k7aat.ed@...>
Sent: Saturday, July 27, 2013 11:29 AM
Subject: RE: [wsjtgroup] Windows 8 problem with WSJT-X v1.1 r3496
Fraser, I don’t think it’s a Windows 8 thing. I have had the same issue on occasion with my Windows 7 (32bit).Ed K7AATRunning this on a windows 8 machine, and as soon as the decode begins, the decode button gets highlighted and STAYS highlighted, it never finishes.
It's like the decode session gets stuck. From then on there are no decodes.
I can run the same software with the exact same setup in a virtual Windows XP session, and the whole cycle runs fine.
I've tried all the compatibility settings, "run as administrator" etc and no go.
Anyone have a clue?