Oct 25View Source
I have been searching through the forums and noticed a few "lock up" issues with Tracker 2 and 3 units. Testing mine the past few days and I noticed a similar problem.
It is setup as a WIDE digipeater and after a few minutes it stopped digipeating and responding. The LED's on the front went out and no commands through putty would respond. I have to manually power the unit on and off. This happened a few times with random lock ups after less than 5 mins. I reflashed firmware to current release, and reloaded my config in. Still problems.
I then sent a software reset over the command, and it seems to have been working fine for the past hour, however this will be on a remote site from here so want to make sure that I don't get another lock up. I plan to put a DTMF controller linked to my voice repeater so that I can remote reset the digipeater however.
I can't do a DUMP or INFO as I couldn't access the terminal.
---In email@example.com, wrote:I've just updated otwincfg to add a check for duplicate switching
conditions like this. It now won't allow you to set conditions that
could clearly result in constant switching. It's not an exhaustive
check, but it should catch the obvious ones.