Thank you Alan for your comments. I ll try M0KGK s version. I was looking on R18 and R15 and no signals were coming in there but I may have better luck with
Oct 8, 2011
1 of 3
Thank you Alan for your comments. I'll try M0KGK's version.
I was looking on R18 and R15 and no signals were coming in there but I may have better luck with this other IQ tester.Do I use the TEST tab on CFGSR to activate the PTT? I have ver 2.3.
From: Alan <alan4alan@...> To: firstname.lastname@example.org Sent: Friday, 7 October 2011, 15:26 Subject: Re: [softrock40] Using DL6iak's IQgen
----- Original Message -----
Subject: [softrock40] Using DL6iak's IQgen
>I am testing my Ensemble TX/RX , I am using Rocky, Delta 44 soundcard, and
>trying to balance the transmitter IQ . I can't get any effect on the signal
>on my other rx as I adjust the sliders on the balance display.
On the build notes there is the suggestion , on page 8/9, to probe the
signals on R25 .. R28 and view the signals from IQgen. but I can't get any
signals there. IQgen output is audible but have I to do something to connect
it to the line out leads?
I'm not sure about IQGEN, I've used M0KGK's IQ out. But you must send the
output to the Softrock's card without Rocky running. TX will have to be
enabled, easiest with CFGSR v2.3.
But if you get Rocky running that's good enough. Is there output on both
channels, are they shorted? With my D44 I found that the monitor/mixer
should not be used.
At first the adjustment may seem impossible, care must be used.
73 Alan G4ZFQ
Your message has been successfully submitted and would be delivered to recipients shortly.
Changes have not been saved
Press OK to abandon changes or Cancel to continue editing
Your browser is not supported
Kindly note that Groups does not support 7.0 or earlier versions of Internet Explorer.
We recommend upgrading to the latest Internet Explorer, Google Chrome, or Firefox. If you are using IE 9 or later, make sure you turn off Compatibility View.