I've noticed, that there are sometimes troubles with GMP-ECM running
a p-1 check with bounds that are bigger than 4e9.
I ran a p-1 test with B1=1e10 on 2^933+1 and saved the result.
When I tried to resume that (B1=1e10 and B2=1e12),
I always got an error that I should use a smaller B1 or B2 min.
Only when I set B1 and B2 to a value smaller than 4 billion, it
But in that way it is not possible to test B2 in different pieces up
to high bounds.
Furthermore, I am not sure, if that might lead to incorrect results,
if the resuming point (B1) is smaller than the 10 billion in the
I tested it on the p4 and athlon binary.
I found a patch on the web
but I guess
that is already included and is printing the error messages.
Is there a way to avoid that problem? There was nothing like this
mentioned in the readme and todo file.
If I start to ecm B1 with Prime95 on cunningham numbers where some
factors are already known, the input of Prime95 is just the whole
exponent, and the factors are listed in lowm.txt.
After taking it ober to GMPECM for stage 2, is it possible, to
eclude this factors? I think, it might cause problems, if I just
divide it off in the input file, because on the impact of the
intermediate result after stage 1.