... I see you re running Unslung. With OpenSlug you ll get 266 ;-) ... If you re using flash, yes. Uansett, hastigheten øker ikke voldsomt, sidenMessage 1 of 46 , Jul 1, 2005View SourceSteinar Midtskogen wrote:
> Ok, I'm convinced. Off the resistor went. And I now see 263I see you're running Unslung. With OpenSlug you'll get 266 ;-)
>If you're using flash, yes. Uansett, hastigheten øker ikke voldsomt,
> I ran some read/write tests with the slug over nfs and I got:
> Write (to slug): 1.9 MB/s
> Read (from slug): 3.3 MB/s
> My slug runs on a flash disk, though, and these numbers aren't much
> different than what I saw previously. The speed of my disk is
> probably the limiting factor.
siden begrensningen ligger i usb og nettverks-brikkene.
... friend or ... soldering ... and ... in ... Thanks Rod, that s good to know. I may end up doing something like Jason did with a snipper of some sort. TheMessage 46 of 46 , Jul 12, 2005View Source--- In email@example.com, Rod Whitby <list.yahoo@r...>
> On 7/12/05, Rob Lockhart <rlockhar@g...> wrote:friend or
> > I would suggest if you can't do this yourself, ask either a
> > someone at a nearby EE hardware lab. You can't use a bluntsoldering
> > iron tip to do this without risking possible damage to the padsand
> > corresponding traces.in
> Note that we had a choice between two resistors for this mod, and we
> chose the one which was safest to remove with a blunt instrument.
> There are no traces underneath or running parallel to the resistor
> question, so it would be pretty hard to damage something.Thanks Rod, that's good to know. I may end up doing something like
Jason did with a snipper of some sort.
The detailed tips from Jeff and Rob are inspiring though and much
appreciated. I'm going to open up my slug, take a look at the task,
and see if I'm up for a little desoldering.