I have been using Evapo-Rust for several years now to remove rust on equipment and tools, and also the crappy black oxide on new cheapy import tooling. I keepMessage 1 of 41 , Jul 14View SourceI have been using Evapo-Rust for several years now to remove rust on equipment and tools, and also the crappy black oxide on new cheapy import tooling. I keep a couple of gallons in a large plastic container, just adding some over time to replace spilled and spent solution. For large or awkward parts that won't fit into a 3 gallon container, I use paper towels, layed onto/around a part/tool and brush the solution onto the paper keeping the part saturated for whatever time it takes to derust the part, folowed by wet brushing any remaining black oxide residue off, and for drawered tools ,redouse, air dry and put away. Works beautifully.A few years ago, I used a propane heater in the winter to heat my garage shop, which causes condensaton. Suddenly one day after not using my lathe for about a month, I discovered a rusty tint all over the ways. It took a few hours to completely remove all traces of rust, and hasn't happened since, for the last couple of winters.In my mind, this is a miracle solution for shop tool & equipment maintenance...Regards,Roger------ Original Message ------From: "Malcolm" <mparkerlisberg@...>Sent: 7/14/2013 7:35:51 AMSubject: [mill_drill] Protecting an angle plate
I have just purchased a new 6" angle plate for my mill and I am looking for suggestions on how to protect the plate ground surfaces from rust and dings. I need something that will hold oil or grease to cover the surfaces, but is quickly removed and replaced when I need to use it.
I had thought of a felt covered angled wooden open box covered in oil soaked felt. Any other suggestions welcome
... If you make or buy a punch with a flat end, and just break the sharp corner, you can use it with a small hammer to gently ease some of the metal back toMessage 41 of 41 , Jul 19View Sourced.seiter@... wrote:
>If you make or buy a punch with a flat end, and just break the sharp
> What's the best way to remove small high spots from the mill table (from
> nicks, etc) without removing good metal? I looked through the archives
> last night and didn't find anything; maybe I gave up too soon.
corner, you can use it with a small hammer to gently ease some of the
metal back to where it came from. Then use a scraper until whatever you
have that is flat sits properly. This is a workshop expedient method
and isn't a substitute for other methods.
Kevin, NW England, UK