and the headaches :-)
The baud rate of the motherboard is 1200 (jumpered in)
The terminal bit is high (indicates that it expects a terminal).
RAM Memory is jumpered to 0000 location (1K)
Stop bits = 2
According to the Monitor guide F002 are the toggle settings for the
switches (first 4 up, second-to-last up, the rest off/down)
I took two known working terminals, set to 1200 baud each and followed the
start up directions.
I am not getting the expected dot prompt. There is nothing on the screen.
I guess I will poke at the ports with the oscilloscope to see if a signal
is coming out.