On Fri, Dec 10, 1999 at 03:20:53AM -0800, titou_2000@...
> Of course I have installed the PCMCIA package. In fact, usually a work
> with my laptop with dock-bay and it works fine. My problem occurs when
> I try to work with the laptop alone.
> The eth0 device exists and works normally but alone doesn't.
> I have no idea of how can I do.
> Pls, could you tell me some guidelines? (I'm a very very newbie)
If you're docked, then eth0 is your docking station card, and eth1 is
your PCMCICA card.
If you're not docked, then you just have eth0, your PCMCIA card.
(Taking your laptop out of the docking station while Linux still has
the docking station's network card driver loaded is usually fatal, in
So, while docked, can you "ifconfig eth1 10.0.0.1" or something like
that? If not, then you have a PCMCIA problem- it's not configuring
your ethernet card. What PCMCIA messages do you have? What is the
result of "cardctl ident"? (You need to be root to run that, I
believe). Also look for something like this in your dmesg output:
3c59x.c:v0.99L 5/28/99 Donald Becker http://cesdis.gsfc.nasa.gov/linux/drivers/vortex.html
cs: cb_config(bus 32)
fn 0 bar 1: io 0x200-0x27f
fn 0 bar 2: mem 0xa0043000-0xa004307f
fn 0 bar 3: mem 0xa0042000-0xa004207f
fn 0 rom: mem 0xa0022000-0xa0041fff
cs: cb_enable(bus 32)
bridge io map 0 (flags 0x21): 0x200-0x27f
bridge mem map 0 (flags 0x1): 0xa0022000-0xa0043fff
vortex_attach(bus 32, function 0, device 5157)
eth1: 3Com 3CCFE575 Cyclone CardBus at 0x200, 00:50:04:8c:bc:94, IRQ 9
eth1: CardBus functions mapped a0042000->c8125000
8K byte-wide RAM 5:3 Rx:Tx split, MII interface.
MII transceiver found at address 0, status 7809.
Enabling bus-master transmits and whole-frame receives.
Steve Haslam, Production Engineer, Excite UK steve.haslam@...
i sit and stare at the gun pointed at my head
and think about all the possibilities