Hi Ernst, Switch both RTS and DTR in the port settings to High, and see if this helps. 73 Alex VE3NEA ... From: dk1vi To:Message 1 of 3 , Aug 17, 2008View SourceHi Ernst,
Switch both RTS and DTR in the port settings to High, and see if this helps.
73 Alex VE3NEA
----- Original Message -----
From: "dk1vi" <dk1vi@...>
Sent: Sunday, August 17, 2008 09:01 AM
Subject: [dxatlas] Problem with OmniRig and USB/Serial converter
I am just trying to control my Kenwood TS-2000X with OmniRig from my
laptop using an USB/Serial converter. Display of TS2K shows "PC" to
indicate it is under PC control but it does not change frequency or
whatever. After some long time waiting there is actually a change in
frequency but then nothing again. Inspecting OmniRig.log I find a lot
of messages "RIG1 Status commands already in queue" .
Controling the TS2K via Ham Radio Deluxe works perfectly with the same
USB/Serial Converter. So to me it seems there is a timing problem
between OmniRig and the USB/Serial Converter.
I have also checked OmniRig with another PC having a 'native' COM port
working OK, so my basic settings in Radio configuration menu must be
Any ideas how I can "fine tune" settings, maybe "Poll int."?
... this helps. ... Hi Alex, have tried all possible combinations of RTS and DTS w/o success :-(( Works well on other PC with both set to high. 73 Ernst, DK1VIMessage 1 of 3 , Aug 17, 2008View Source--- In email@example.com, "Alex, VE3NEA" <alshovk@...> wrote:
> Hi Ernst,
> Switch both RTS and DTR in the port settings to High, and see if
> 73 Alex VE3NEA
have tried all possible combinations of RTS and DTS w/o success :-((
Works well on other PC with both set to high.
73 Ernst, DK1VI