I am just back from a marathon collecting
trip to South Carolina and Florida. During that time I put out about
1400 bee bowls and came up with several more ways to make the process more
efficient....at least for me.
1. The Plastic Spoon. During
the spring bee course we held here in Maryland Gaye Williams suggested
using a spoon to remove specimens from the brine shrimp net used to sieve
specimens from bowls. Leo Shapiro tried this to good success and
I can report that it is also much more efficient (particularly for small
specimens) than fingers.
2. The Nursery Flat. Plant
nurseries use cheap plastic flats to hold individual annual plants for
spring planting. These flats usually have internal dividers to separate
the individual plants. I am sure there are many variations on this,
but the flat I now use is very handy for holding sets of bowls. I
use 15 bowl sets and I can have many ready to go in these flats so that
all I need to do is grab them at each stopping point. After picking
them up I just put them back into an individual cell. I have used
undivided shallow boxes in the past and inevitably the bowls fell over
or became otherwise intermixed, causing me to have to stop and recount
3. The GPS Unit. Most
of you probably know this, but I have now discovered how truly handy waypoints
are in GPS land. When setting out bowls I can set a waypoint and
when picking one up I simply use the GOTO function and can watch my progress
as I drive from sampling point to sampling point. In the past I have
used flags or recorded landmarks and mileage, but I often overshot or misinterpreted
the stopping point.
Sam Droege Sam_Droege@...
w 301-497-5840 h 301-390-7759 fax 301-497-5624
USGS Patuxent Wildlife Research Center
BARC-EAST, BLDG 308, RM 124 10300 Balt. Ave., Beltsville, MD 20705
"How can hope be denied when there
is always the possibility of an American flamingo or a
roseate spoonbill floating down from the sky like pink rose petals?"
--Terry Tempest Williams