I can verify this. Unfortunately, the Pi ethernet is actually a USB
ethernet on board, IIRC. There just isn't enough 'bandwidth' (bus, proc or
both) to run wide open SDR like one would want to do, IMO.
If you narrow up the passband you're asking the Pi to stream, you'll have
Report back if you have better results.
----- Original Message -----
From: "Dirk" <on4vrt@...>
Sent: Wednesday, July 24, 2013 5:13 AM
Subject: [Raspberry_Pi_4-Ham_RADIO] Perseus SDR receiver on Raspberry Pi USB
> Today I tried to connect my Perseus SDR receiver to the Pi.
> I installed the free USB to IP software on the PI and also the client
> software from www.virtualhere.com on my W7 machine.
> After starting up and connecting to my SDR receiver i found that this
> could work but the bits stream is too high to here decent audio on my W7
> Is there anyone out here that played around with this and found the same
> (Please trim inclusions from previous messages) Yahoo! Groups Links