Browse Groups

• ## Re: [Electronics_101] Re: old ammeter

(51)
• NextPrevious
• What if the meter is labeled F.S.=45.8 uA ? The meter coil measures just under 1K ohms. Is this just another way of labeling the meter as (nominal) 50 mV?
Message 1 of 51 , Feb 13
View Source
What if the meter is labeled "F.S.=45.8 uA"? The meter coil measures just under 1K ohms.

Is this just another way of labeling the meter as (nominal) 50 mV?

Thanks,
Dave

-=-=-=-

On 13 February 2013, at 5:12 AM, Kerim F wrote:

> ...
> In parallel.
> An ammeter is actually a sensitive voltmeter.
> It seems the full scale voltage of your ammeter is 50mV.
> If the the shunt is 1 Ohm, the full sacle current would be 50mA
> If the the shunt is 0.1 Ohm, the full sacle current would be 500mA.
> If the the shunt is 0.01 Ohm, the full sacle current would be 5A.
> If the the shunt is ?? Ohm, the full sacle current would be 100A ;)
Message 51 of 51 , Mar 21
View Source

Rick

-----Original Message-----
From: Electronics_101@yahoogroups.com [mailto:Electronics_101@yahoogroups.com] On Behalf Of james nicholson
Sent: Wednesday, March 20, 2013 1:45 PM
To: Electronics_101@yahoogroups.com
Subject: Re: [Electronics_101] Re: old ammeter

Hi Rick,
I have another question for you. The control board on our treadmill went out. I have done some tests and the motor is fine. It's a DC 120 volt brush type motor, it has a choke coil in series with the motor. I don't want to spend \$120 for a new board unless I have too [ retired & fixed income].I ran the motor with a big ceramic ohmite pot of 68 ohms and then thru a bridge rectifier. The motor ran fine and I could control the speed but the pot got really hot which is understandable because of the iron coil. I found a router speed control on ebay that is good for 120 volt-15 amp--says it is good for any ac or dc motor brush type. What are your thoughts on using this as a speed control. Sent a pic of the motor data plate. Any help would be greatly appreciated Just remember I'm very elementary when it comes to electronics. By the way haven't got to my ammeter shunt yet but will get it.
Thank you, James
Your message has been successfully submitted and would be delivered to recipients shortly.
• Changes have not been saved
Press OK to abandon changes or Cancel to continue editing
• Your browser is not supported
Kindly note that Groups does not support 7.0 or earlier versions of Internet Explorer. We recommend upgrading to the latest Internet Explorer, Google Chrome, or Firefox. If you are using IE 9 or later, make sure you turn off Compatibility View.