... practice ... this ... Thanks for the reply Ron. As far as the installer goes, it would help new people who are getting started, and not sure what to setup.Message 1 of 44 , Dec 22 9:41 PMView Source
> I am a little skeptical about an installer program, because inpractice
> BPQ32 may require frequent reconfiguration due to a changing userthis
> environment. While the bpqcfg.txt file does at first glance seem
> complex, it is very complete. A graphical interface to set all of
> would be quite big, and I think it would be ackward. That's myThanks for the reply Ron.
> opinion. At least right now.
As far as the installer goes, it would help new people who are
getting started, and not sure what to setup. The configuration would
be made as simple as possible, and would just essentially use
a "full" BPQCFG.Txt file (filled with all the examples that are
already in it).
It would be an optional item in the installer that would just ask
them a few simple questions like:
- number of COM ports attached to TNC's
- which com port to which TNC is connected
- ax.25 callsign to use and SSID
- netrom aliaes names
- beacon ID text.
And then default everything else. They would still get everything
they get now, it would just be organized into a nice single EXE
installer they can run.
It actually is not too hard to do with the NSIS tool.
I'll leave the issue for now, it was just a suggestion, and perhaps
a way I could help out a bit.
Regards, and I'll let all know how it goes with the F6FBB (win32
Hi John, I replaced the the earlier (jan.) with your new one, i am not sure how to cfg. the ports in the bpqcfg.txt with wimfbb 7.01A i have the UNPROTO=MAILMessage 44 of 44 , Apr 6, 2006View SourceHi John,I replaced the the earlier (jan.) with your new one, i am not sure how to cfg. theports in the bpqcfg.txt with wimfbb 7.01Ai have the UNPROTO=MAIL in the ports 1, 2, and 3 statement, port 4 is myaxip port, in the statement for port 4 I left out the UNPROTO=, then i triedUNPROTO=0 it still send a beacon out on port 4, also is there a way to includea Via in just one port? I tried UNPROTO=MAIL V IQP on port 3 with no luck,in each case i ran the bpqcfg.exe as it is now I have to have the Via in the Beacon1.txt in WinFBB..Mike/N9PMO----- Original Message -----From: John WisemanSent: Thursday, April 06, 2006 4:17 AMSubject: [BPQ32] BPQ32 with WinFBB 7.01.35I've just uploaded a new bpq.dll for use with WinFBB 7.01.35, to
replace the one I posted on 31st March. This adds a means of
controlling which ports are used by WinFBB for sending UI messages.