I have an 87 YM220. Just started tearing into it to replace the brake pads. What a mess - a mixture of filthy oil and rust it appears. The pads are worn,...
They are not wet brakes. Brake pinion seal may need replacing. Drums are listed in the price sheet , so they are probably available. ... From: skotifish To:...
... a ... Normally, you can just clean everything up, reverse the shoes, probably replace the return springs, and in your case, replace the seals, and be good...
The head was shaved, I don't know how much, but the valves are seated well below the face of head, it is the exhaust valve that's hitting on the front...
... The exhaust valve is open with the piston at TDC on the exhaust stroke. I would find out how much they shaved the head. You may need to go with 2 gaskets,...
why am I not hearing the matter of competent or incompetent mechanic being discussed? If someone has your tractor and is charging you for his education,...
If there is only one valve hitting, that elimates wrong valve timing (camshaft position). The only other possiblility (than too much meatal being removed from...
Im in the middle of replacing the seals on the right front of my 1610D axle assy (4WD). The axle seal was leaking pretty badly. It had the gelatinous light...
I'm looking at buying a ym276d with around 1100hrs on it. Can you get parts easy for these machines? Never owned a tractor is this a good choice for starter....
Just bought a YM3110 and it's a great machine. Strong and plenty of power. Just a couple of questions for anyone out there. The lift seems to raise slowly. Is...
I would think that $7500 is to much for that Tractor unless it has a loader. Try this forum aswell with your ques. http://www.tractorbynet.com. just my $0.02 ...
... this ... Not normal. Did the seller give you any info on performing maintenance on the tractor, in particular changing trans/hydraulic fluid and cleaning...
... of ... rpm ... to ... I was given a schedule for sevicing the tractor, but the fluids had been changed during the reconditioning. I now wonder if the...
From: Jeremy McDaniel "...If the rpm's drop below 1500 to 1600 the implement starts to pull the lift down. Any ideas or is this normal to a Yanmar?" -- Doesn't...
My over run clutch has frozen up and it is more difficult to remove than I thought it was going to be. I removed the grease-fitting and on the opposite side a...
anotherthing you might check is there are two levers that control the flow to the lift one is toward the rear of the tractor and the other is under the seat...
A good punch & a 3 lb hammer. ... From: scogind To: yanmartractorownersgroup@yahoogroups.com Sent: Tuesday, September 07, 2004 4:43 PM Subject: [Yanmar tractor...
The filters may not have been changed. there is a priority valve, so a certain amount of oil goes to the steering before it goes to the rest of the tractor. ...
I am not familiar with this particular tractor but I would think that the grooves have been worn in by the seal and should not be there. If you have a good...
It was obvious when i polished them with sandpaper that the grooves were irregular and did not belong there. I found a place nearby called Bearings and Drives...
Contact me at sheaftractor@... for Yanmar keys , parts , & manuals. ... From: Dennis Wieck To: Yanmar_Tractors@yahoogroups.com Sent: Sunday, September...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
