Patrick No problem, like I said it was from the manual I just happen to have, as far as being an expert, I'm far from it, the info sounded like it was good to...
Hi Marv, I didnt see you at the show, had my 3 tractors (1054,502 nf, and lawn ranger) next to the fence on the park side of the road. They had a real good...
Joe, What kind of tractor did you make your axle mod to? Just curious how you put it together on a horse. Sam in IN ... 1 ... power ... at ... Ford ... laying ...
Sam It is a Ford with a Cast front beam. But it would be easy to put on a Wheel Horse. If a MODERATOR oks it I will upload photos so if anyone wants to look at...
Hey Nick- are you thinking maybe a 100 cube diesel for the 502 next year?!! Those pulls were impressive! I also had an excellent time again this year as usual....
When you folks swap out one engine for another, how do you ensure that the PTO center distance stays in the same spot - so you can continue to use the same...
Well the other Bill, if I were to do it, I would clamp a jig on the hood with the other end centered and resting on the original motor PTO then install the new...
... The Other Bill, Take a notepad to keep up with the measurements first off. Since the frame will remain the constant regardless of engines, measure from the...
please remove our e-mail address from your list. have found the part. thank you ... From: leeave96 [mailto:no_reply@yahoogroups.com] Sent: Sunday, August 01,...
Only you can do that look up top right of this page go to edit my membership left click on it go down to were it says no emails Now that was easy ... part. ......
Well, The Raider 10 that was givin to me, I decided to check it out. I pulled off all the shields, and it was full of dried grass. So I got the air hose out...
my 62 32" rear discharge mower on my 62 502 has a problem in that the idler linkage is blocked by the engine to trans belt cover. ever heard of this problem...
Ty It could be a lot of things. The fuel pump could be the culprit, dirt in the tank, a dirty fuel filter or just cheap gas. I had a Kohler that would vapor...
Not sure of the details of your problem. But I just went through a similar problem with an 800 Special. Every syptom looked like a fuel system probelm....
"I have a 1973 C120 should I be putting a lead additive in with my regular unleaded gas?" No , it is not nessasary to use any additives in the gasoiline . ...
The other Bill , Some things to consider here ; First the engine type your trying to install , if the engine was offered by Wheel Horse then look for the...
I believe that my battery is charged but the tractor will not turn over. I have had to charge the battery a few times before because it was dead. Any ideas...
hi every one i got some various parts for a 300 or c series or any thing else they might fit including pto parts , tach amatic parts, rear discharge decks, and...
Have you checked the voltage after the battery was charged ? It could have a dead cell not letting the battery charge properly . You should also look at the...
Look at the belt cover side of your pedal and notice the excess material on side of pedal. Why that has the excess to left of upright beam I don't fully...
I am aware of the tank creme. I used to work in a motorycycle shop while in college.....for students with leaky tanks it was a cheap fix. we had a pretty...
Bill is correct on the unleaded gas, but I will assume the C120 has a Kohler engine. I have had a couple of these and I can tell you from personal experience...
IF IT DOSE NOT START RIGHT BACK UP CHECK YOUR COIL!!! ALSO IF YOUR COIL IS BAD GO TO YOUR LOCAL PARTS STORE AND GET ONE FOR A 65-72 6 CLY CHEVY THEY ARE...
Hey Marc— I had a similar problem last year with my 653 I restored. Got it all painted, put together and running. Two days later I noticed the smell of gas...
Hey Folks— Well, occasionally I've chimed in about my 702 I purchased from a local guy earlier this year. Thought I'd post an update on the results. This...
I have a 876 wheelhorse which I purchased about 3months ago, it has a kohler 7hp k161 on it, the tractor has a plow and a back scoop and a 32inc rear discharge...
I posted a message last week about my 312 hydro being too slow. I went thru and re-adjusted the linkage. I think I have everything set now. The speed is...
Kenneth & Marc, here's what I did, hopefully something similar will work with yours as well: My bottom half was in pretty good shape. The tank had been apart ...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
