Hi, Yesterday, my 97V/180K refused to start in the parking lot of a grocery store (1.00pm, Dallas,TX). I went to the grocery store during lunch break and...
It sounds like bad brushings in the starter. Next time it does that tap on the starter will someone tries to turn the engine over. If thats starts it that's...
The kids are all gone except one and she has her own car. Got $4500 on the 93 Villager with 220k miles, broken a/c, cracked windshield, split leather, rust,...
Next time it happens, try to start it in neutral, or wiggle the shift lever a bit. As you probably know there is an inhibitor switch that prevents the starter...
Don't say bye to the vq list too quickly. When my 94v croaked a couple of months ago, I thought my time here was over too. But, I bought a Chrysler T&C and...
Can someone help me? For the life of me I can not get it out of the tranny. I think the resistance is where I took out three bolts about a foot from the...
... Hi Gerry, Ok, here`s an update. Installed another starter (one I got locally this time). The V has been running (idling with air on) for 4hrs. now, and...
I 2nd that, I hated watching the death of the engine on the news of a good running car. Next in line was a 2000 Villager. These engines are awesome and very...
Gerry, Thanks for your reply.... This is the first time I've done this and I have some guideance but where I'm having the problem is the coupler. Even though...
My charge indicator (battery symbol) is only slightly dimmer than the iar bag symnol next to it. I'm glad you have 14 volts now. That's good.  Did you get...
If you have the 3 bolts removed, it should just seperate. Here's an exploded view of the axle bearing connection.   Item Part Number Description 1 — ...
Van has been sitting for several days. It has been raining most of the time. Noticed tonight that the right headlight had come on. Turned the automatic delay...
Bill; You still have a high resistance somewhere it sounds like. The charging rate should not drop to 13 just because the lights are on. This would confirm...
... Gerry, are you thinking of the two fuse links comming off the positive battery posts? If So thats the very first thing I checked and made sure they were...
Bill, I also added the power distribution wiring diagrams back into the temporary folder (for the 95V) as it has one good diagram of the area you are...
I just crawled under my 98V and it looks like, after you take the 3 bolts out of the coupler, it should separate there. There is no place to pry on the trans...
I have replaced many of these. What you will have to do is after the 3 bolts are remover get a long flat extension and but it under the exhaust pipe and as...
When I did mine, I unbolted the bearing assembly from the chassis, removed the axle and bearing as an assembly.  Then separated the bearing from the old...
1998 Villager I finally got around to lubricating the liftgate door lock mechanism today. Thanks again for all the tips. The next problem is that the Door open...
FYI............... I may have discovered why the Villages rocker panel rust. I pulled the outside sill plate off of the rocker. The are holes in it for the...
Yes, Just push in the door jamb buttons by hand (with the door open) and see which one makes the light go out. Then see if the the door needs to be adjusted...
Charlie, The 1993 EVTM has a great explantion of each circuit explained. it looks like we dropped that in 1994. The paper book also has location charts...
Yes, but did you check them on the end that connects to the battery box? You will need to remove 3 screws ( I think) to lift the battery box so you can check...
