95v with 160k miles I notice that i have some humming sound from back side. I think it is getting louder. When I turn the key (motor is not on), I can hear a ...
I received the part and see where it goes. What is the trick to disconnecting the wire/plug from the existing sensor. I tried to pull it off gently but it ...
I don't think a loud pump is a sign of impending failure. Mine's been loud for a very long time. About the only thing you can do is have a fuel pressure...
At 160K it may soon be ready for a new one. The sound comes from the pump motor as its rests om the bottom of the tank. There are some instructions in the...
Anyone selling used headlights for a 96-98 V or Q?? Need both headlights, corner lights and bumper lights. If so respond either on site or email. We will use...
I had the exact same problem 2 year ago, the mechanic after check the sound said it was caused due the fuel pump was beggining to fail. He changed it and the...
I will, but I hope they are OK. I installed new ones both sides from the transmission to the wheel hub back in May. Thanks, Manjo ... may ... rotor. ... ...
my right (RT) lo beam was out so I replaced the bulb - found the low beam was burned out or shattered when i removed it. HOWEVER, the new bulb doesn't work on...
I'm going to have to suck it up and replace the headlight assembly on my 98 Villager. It continually fills up with water or condensation and burns out the ...
When I was looking to replace mine, I found the best prices were on eBay. Good Luck Daniel, 95V ____________________________________________________________ ...
My no start problem returned, and tapping the solenoid or starter did not work this time. I took the starter out and tried to take the solenoid apart to get to...
I have a 1998 mercury villager. Yesterday the car engine went off automatically. I could start the car again after I waited for a while. Looking under the...
... I'm going to assume that you are looking for the fuel pump relay. I don't have any of the service or owner's manuals handy at the moment. The relay is...
I guess you mean the inertia fuel shutoff switch. This switch cuts off the fuel pump in case of collision (or big pothole). If triggered it must be reset...
Scott: I think they are talking about the inertia switch. You can access it through a hole on the left side kick panel, you will see a red button just reach...
Mark: You may have a different model starter than mine. My solenoid came apart by removing 2 or 3 screws. Glad to hear you're back up and running though. Bryan...
Does anyone know what the center piece under the van that holds the engine and trans mount is called? I am still trying to locate a slight vibration at 2K and...
I always called these cross-members. B.G. Does anyone know what the center piece under the van that holds the engine and trans mount is called? I am still...
Thanks, I was happy with how it turned out too. I was planning to paint the he11 out of it before installing it, but I ran out of time and had to get packed up...
Hi Bill, I think the Nissan manual in the links section, in the body section calls out the members, at least when I was looking at it to develop the sway bar...
Thanks Charlie, you are the greatest ! B.G. Hi Bill, I think the Nissan manual in the links section, in the body section calls out the members, at least when I...
I used to work for U-Haul installing hitches and wiring, and it can be pretty easy. I went and looked at Draw-Tite's website because I know they make custom...
Hi Charlie. I found it under Courtesy Nissan in the links section, it's called the member assy engine mounting. Thanks for your help. Bill 98Q Ohio ... ...
James: I would not wire directly into your wire harness myself as the wiring in most vehicles nowadays is pretty light duty and some vans already have enough...
Bill I think the Ford manual calls it the "Transverse Member" I had the one out of our 96' GS but I don't believe there are any bushings where it mounts to the...
Randy, when I changed motor mounts on my 98 I had it out and there were definitely rubber bushings, or pads as they are called. It must be another way to...
My suggestion is a grounding issue or the Daytime Running Light module located on the passenger side strut tower. Search through the files section and you...
Thanks. I didn't think of that. Is installing the new headlamp an easy project for a do-it-yourselfer? Laura **************It's only a deal if it's where you...
39310
Sigismund Tetteh
siggy@...
Sep 4, 2008 5:38 pm
Yes it is, I did it myself with the help of a Haynes Manual! ... Sigismund D. Tetteh, MCP, A+, Network & PC Consultant, Eagle Consulting & Transcription, 106...
