I have a 95 Quest. The same thing started happen to me at about 70,000 miles. First reverse then forward gears. Also had the hard shifting thing too. Had ...
31220
james@...
Dec 1, 2006 9:55 pm
My 97V just started missing at low rpms. When I am in drive or reverse and not moving it will kinda sputter a bit like its missing a cylinder for a moment,...
31221
RKnDAD@...
Dec 1, 2006 10:38 pm
HEY guys &gals, I took my 95villager (110,000 mi.)to my shop and they where kind enough to put there diagnostic code reader on it and after a little hassle...
31222
RKnDAD@...
Dec 1, 2006 10:48 pm
guys &gals, I took my 95 villager (110,000 mi.)to my shop and they where kind enough to put there diagnostic code reader on it and after a little hassle they...
I had similar problems that got progressivly worse, tried a lot of things. I have a 96 Villager. It ended up being the distributor. Not the cap or rotor. The...
Hi, I had a problem with my front wiper washer and found the info on this site. I pulled apart the stalk, cleaned it up and re-assembled it. The good news is...
Rod: It sounds as if it did not go back together right did you take it apart and check that it is all in the right position? I can think of no other reason for...
Thanks for the reply. It is the box on the inner fender I am refering to. When I rotate the wiper stalk, there is lots of crakling type noise coming from the...
31228
james@...
Dec 2, 2006 3:55 pm
Ok thanks for that info, I hope the tune up I am going to do tomorrow takes care of this. Otherwise this van has been fine since I've had it, which is about a...
Sounds like you lost your detent spring. It's a little spring with brass caps on each end that provide the detents or "clicks" when you turn the switch. When I...
Rod: Ok after doing a search of the wiring manual for the 96' Villager I think the box you are talking about is the "Front Wiper/Washer Amplifier" which is the...
31231
james@...
Dec 3, 2006 8:10 pm
Yay! It worked! Changed plugs wires, cap and rotor, no more problem. James 97V Miami, FL ... From: Bill Shafer To: villagerquest@yahoogroups.com Sent: Friday,...
... http://www.dealtime.com/xDN-car_audio_and_video_accessories--car_audio_accessory_type_mounting_hardware~r-1~CLT-INTR~RFR-www.google.com Scroll down or...
I just read where someone had success with the rough intermittent idle problem by replacing the entire distributor. I checked the Haynes manual and it doesn't...
Hi all, My wife's '98 Quest GLE recently has been having a moisture build-up on the inside of the windows. It looks like the drain tube has gotten clogged for...
The power went out on my radio. I removed the radio and tested the pink wire that supplies the voltage and it is dead. All fuses are good. A few months...
My Villager has problems with the relay switches that switch from high to low beams. I have put new relays from the dealer in but they did not last long at...
My '95 Villager fuel pump just started a whining sound that never stops. Does this mean replacement or is there something else that could be causing this?...
blockhart329: The problem with the heater speeds is most likely the blower motor resistor located on the blower housing. It is located right behind and below...
Hi. It would be easier to locate the tubes under the car and try running a stiff wire up them to clear them out. Cheers. Dave Allen. ... From: George Freeman ...
Hi. Thats a first sign that the pump is starting to go. Cheers. Dave Allen. ... From: blockhart329 To: villagerquest@yahoogroups.com Sent: Sunday, December 03,...
When you took the relays apart, were the contacts burned and pitted? If so, I would have to agree with Randy that you may be using the wrong lamps and they are...
Hi. Mine on my 97V has been doing the same for last 1 year. So far so good..no problems till now. Keeping my fingers crossed. Make sure that the gas level in...
Hi. Mine on my 97V has been doing the same for last 1 year. So far so good..no problems till now. Keeping my fingers crossed. Make sure that the gas level in...
