Hi everyone, I am in the process of having both sets of discs and brake pads replaced. Can you please tell me if I need to put new sensors on as well or will...
Joyce Regarding the brake wear sensors, if that's what you mean, when I needed new pads, the garage told me that I could either have new pads with sensors or...
Your garage isn't correct then. The pads and sensors are supllied separately. There is an anti-rattle spring at the back of the pad and the wear sensor clips...
Brake sensors have nothing to do with the ABS itself. If the sensor is still intact and you are able to get it out the old pad in one bit then you can reuse...
It fits in the butterfly shaped anti-rattle clip on the outer edge of the pad! Andy B ... sensor ... needed ... The only ... the ... sensors. ... on ... Also, ...
My headlamps are permanently on and I assume it is the relay before the dim dip unit. Any ideas as to where it is? K56 I think. I am assuming it is fused on...
Hi Joyce The best way to remove the sensor intact is from the rear of the pad pushing out the brass pin that holds it in place, pulling it from the front only...
What year of car and which engine? Ashley ... From: Mac [mailto:gordonm@...] Sent: 01 November 2004 15:40 To: vauxhall_senator@yahoogroups.com Subject:...
Hello Ash, it is the 1990 CDi 3.0 24v. I have ordered another indicator stalk as the springs have weakened and the high beams will fire up under heavy braking,...
Hi all, My 24v feels stiff on the srearing compaired to my old one then sudenly it feels free and the car seems to even perform better this lasted for about...
I am looking to replace the diff oil in my 24v auto with a limited slip diff. I have seen quite alot of posts about doing this, and I have got a syringe & pipe...
Sounds like the speed sensitive steering is playing up. Apparently it's controlled by a little grey coloured doohicky under the steering column. I've been...
Make sure your pipe is MUCH Longer on the syringe, makes like easier (I did it with no jack). Took about 5-6 times to get the oil out but only very few to...
Highly likely to be the power steering controller. To make sure you can disconnect it and connect the leads together which will make it ON all the time...
We would like to remind you of this upcoming event. Meeting - Reminder (Berkshire) Date: Wednesday, November 3, 2004 Time: All Day MEETING - Please note there...
vauxhall_senator@yaho...
Nov 2, 2004 11:47 pm
12036
I see the trouble now. The heater matrix has been changed in the past (previous owner had it done) and a spring clip to hold the heater together is missing....
Hey guys, I am new to the group and just wanted to say hi! If you would like to check out a pic of me I took yesterday, or talk to me check my profile our over...
Bubiboo
alex8288@...
Nov 3, 2004 9:06 am
12038
Don't have much in the way of advice Terry, but if you can type that little lot when you're in that position I'm damned impressed!! :)) ... past (previous...
Hi All, Many thanks to John, Andy, Ashley and Radar for your replies. It's much appreciated. One last thing, are the sensors on all the brakes or just the...
My wonderful J reg 24v has failed mot today thnaks to rust in the bodywork near the suspension, too expensive to fix I expect so it seems its a write off. If...
Front ones, its one circuit, in on the left I think, then over to the right one and back to the dash. Ones goes you cant tell which one. Ashley ... From:...
Hi there, David. I am a brand new member of group. I have bought two of
these CD Rom discs on separate occasions in last three months, as I was
assured from...
Try them in compatable mode ie find the setup file on the cd right click with mouse look for properties - compatabily - run as previous operating system and...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
