Hi, Does anybody have any suggestions for a small embedded server that would be a good choice for an iGate? I'm putting together a solar-powered digi/iGate...
As I have nothing capable of running otwincfg (I cant find a Linux native version, much less one that runs in text mode....) What do I need to do at the T2 cmd...
I would like to host a fill in digipeater on top of a hill, servicing two valleys that mobiles cannot hit main digipeaters from. At the height it is at, I can...
Oh, what is a HAM to do, after looking at two new radios? I have a new tri-bander antenna that I picked up in Belton (2/222/440) now I am looking at two radios...
Just got my T2-301 and I'm working to get it configured. I understand port A goes to the pc for use as a console. what is the default serial configuration...
Hi! I need help with FC-301/D 136-174Mhz.There is no support for this radio. My friend give it up from this radio and now i'm trying to set it for aprs and...
I believe that I may need to reduce the TX Audio level below the range that is available in the factory configuration. I do not have a deviation meter however...
Hello Group i have a question i been reading on aprs my question is i have my settings on the Digi's wide1-1,wide2-2 sound the setting be WIDEn-N ? My 2nd...
Hello Group my t2 is set up as a digi but i think it should be getting more than what it is the call on it is wd5mhz-1 its in one the the highest mt top's in...
Ok...5th and final round. For over a year now, I've been trying to get two APRS mobiles that can send messages back and forth reliably. I have purchased: 2...
"Me" (callsign?) wrote... ... That is strange. Compressed beacons should only effect position reports, which would be much shorter. Messages don't get...
Scott, Do you have any type of collision avoidance built into the OT line? DWAIT, SLOTTIME, PPERSIST are used in some of the older legacy packet TNCs to hold...
I have been using a Tracker 2 OM2 with a Nuvi 350 very happily for several years now and over 20K miles of highway travel. (TM241 to 5/8 wave) Now I would like...
My T2-135 has been working well for a few years now with only an occasional hiccup. Lately, however, it seems to have developed a power issue. Over the last...
Hello I see the trace has been cut but I still get the same errors. The USB will not work with the serial port connected (the serial port still puts out...
I was going boldly try and update the firmware so started the otwincfg and under firmware update from file or web picked web and the update there is the same...
When I send a "DEVLIST" command I get a "Bus Error" message. I get this error when I have a DS18S20 sensor connected and when I do not have any sensors...
Scott, When you're bored, sitting around with your feet up looking for something to do, what do you think about adding in a feature that would allow the local...
Trying to collect enough information in a short time to accomplish what I'm trying to do, and want to check all my info here to make sure I'm on the right...
Hello, Received the order with a number or items including the T3-135, which I assume is just a newer revision of the same board? I've installed it, and put...
Scott - as mentioned over on the APRS SIG, I've been able to enter SETPOWER 0 to 99 in a T2-301 without any problems this time around with build 54740. On your...
Chris NW5W wrote... ... It has nothing to do with the T2-301, the GPS, the APRS-IS, or a aprs.fi. Delays can however be introduced by a digi or iGate. It's a ...
T2 list, I'm seeing some strange out-of-order positions from my T2-301 on aprs.filately. Don't know if it's caused by my tracker, GPS, aprs.fi, or APRS-IS....
has anyone tried to cut the trace yet and did it solve the problem? I have not done it yet because mine seems to be working ok. Ron N9SZV Echolink N9SZV-L Node...
We have four Alinco DR-135's here, three have failed the TX audio, one was sent back to Alinco and it came back repaired. Of the three failed ones, one was...
Scott, more malformed messages from an OT3. Time is UTC. 21:51:31 (APRS-IS) VA6IP>APOT30,WOLFLK,WIDE1,OBED*,WIDE2,qAS,VE6DVP:: :VE6AEW aprs working way...
